dst_0_v_ref_z01a1b9_00.ps.gz from single reference run
10dst_0_v_ref_z01a1b9_00.ps.gz from 10 DST files
^ ^ ^
| | page number
| mass of product
charge of product
Note, that all plots are for the total trigger cross section as
indicated by the `b9' in all file names.
dst_0_ze_ref_r01b9_04.ps.gz from single reference run
10dst_0_ze_ref_r01b9_04.ps.gz from 10 DST files
^ ^
| page number
ring number (r00 means all rings)
Note, that all plots are for the total trigger cross section as
indicated by the `b9' in all file names.
10dst_0_rm_ref_01.ps.gz
^
page number - one page per system
A quite simple `good hit' selection was used based on
identification code = 1 - 3 (CsI, Si or Chio pid)
calibration code = 2 - 4 (accept warnings, discard errors)
/dat/s185/dst0_plot/v_b9_ref
| inclusive rapidity; from reference runs |
/dat/s185/dst0_plot/v_b9_10
| inclusive rapidity; from 10 DST files per system |
/dat/s185/dst0_plot/v_bx_10
| centrality selected rapidity; from 10 DST files per system |
/dat/s185/dst0_plot/ze_b9_ref
| Z vs E/A; from reference runs |
/dat/s185/dst0_plot/ze_b9_10
| Z vs E/A; from 10 DST files per system |
/dat/s185/dst0_plot/rm_10
| ring-module distribution; from 10 DST files per system |
/d/kp3/bck/s185/dst0_plot/v_b9_ref # inclusive rapidity; reference runs
/d/kp3/bck/s185/dst0_plot/v_b9_10 # inclusive rapidity; 10 runs
/d/kp3/bck/s185/dst0_plot/v_bx_10 # b selected rapidity; 10 runs
/d/kp3/bck/s185/dst0_plot/ze_b9_ref # Z vs E/A; reference runs
/d/kp3/bck/s185/dst0_plot/ze_b9_10 # Z vs E/A; 10 runs
/d/kp3/bck/s185/dst0_plot/rm_10 # ring-module; 10 runs
INDRA Raw and DST Data Documentation